Who is this for?

Solo artist making a quick demo

You want to connect your vocals and instrument in a small booth and create a usable mix as you play. Decide in advance whether a stereo mix will be enough for you later; Yamaha and Allen & Heath describe some models as having a USB route with two inputs and two outputs.

Creator who edits vocals and instrument separately

You want to be able to adjust the balance of individual sources after the session. Check the number of USB recording channels and the routing on the exact model; Allen & Heath lists a 4-in/4-out USB interface for the ZEDi-10FX.

Creator with a different recording setup in mind

You may want to include computer playback in a recording, or record to an SD card without a computer. Mackie describes different USB recording modes for the ProFXv3+ series; Tascam describes the Model 12 as having an internal recorder and USB interface.

What to consider when buying

Compact stereo demo

A good fit if: you capture the balance between vocals and instrument as you play and don’t need to edit them separately afterwards.

Bear in mind: a stereo USB route is limited to the specified USB channels, even if the mixer has more physical inputs.

Separate sources sent to your computer

A good fit if: you want to adjust vocals and instrument separately later and the USB routing on your chosen model supports this.

Bear in mind: the specified number of USB inputs and the selected routing determine which signals are actually recorded.

Recording with computer playback

A good fit if: you also want to use audio from your computer during the session and choose deliberately whether it’s included in the recording.

Bear in mind: Mackie’s Loopback mode records computer playback, so don’t select it automatically if you only want to record live sources.

Recording to an SD card

A good fit if: you want to record without a computer connected and are looking for an internal multitrack recorder.

Bear in mind: Tascam lists the Model 12 under discontinued products on its European downloads page; check the support available for the specific unit.

For an acoustic demo in a small booth, these are four possible priorities to start with. Choose mainly according to how many sources you use at once and whether you’ll need separate tracks later.

Consideration What to check before buying Who should consider this?
Connections Count the microphones and instruments you use at the same time. Check that you have the XLR, jack and any Hi-Z inputs you need, as well as phantom power. If I want to connect vocals and an instrument at the same time, I want to know in advance whether there are enough suitable inputs. Around 36% of consumers give having enough connections their highest priority.
Separate tracks Check how many signals the exact model sends to your computer over USB at the same time, and which inputs are available with each routing mode. Yamaha lists 2-in/2-out for the MG10XU; Allen & Heath lists 4-in/4-out for the ZEDi-10FX. If I want to adjust vocals and instrument separately afterwards, I check how many channels are actually recorded separately. Around 29% of consumers prioritise separate tracks.
Monitoring and routing Check the headphone controls and what each USB recording mode captures. Mackie describes Standard, Loopback and Interface modes for the ProFXv3+ series; Loopback adds computer playback. While I’m playing, I want to be able to hear myself without accidentally recording computer playback. Around 21% of consumers care most about monitoring and control over the recording route.
Recording without a computer Check whether the exact device saves separate tracks to an SD card, and which storage media and support apply to the version on offer. Tascam describes the Model 12 as having an internal recorder; the European downloads page lists the model as discontinued. If I want to record without a computer, I look for a device that can record directly to storage. Around 14% of consumers give this capability their highest priority.

Common buying mistakes

  • Assuming physical mixer channels mean separate USB tracks

    The number of connections on the mixer doesn’t tell you how many separate signals are sent to your computer. Yamaha lists 2-in/2-out over USB for the MG10XU, while Allen & Heath lists 4-in/4-out for the ZEDi-10FX.

    Compare the USB recording channels and routing on the exact model, not just the number of inputs on the mixer.

  • Using Loopback without checking the recording source

    Mackie says that Loopback adds computer playback to the recording. This may not be what you want if you only want to capture the live vocals and instrument.

    Choose the recording mode you need deliberately and listen back to a short test recording before your session.

  • Choosing a computer-free multitrack recorder without checking the version

    Tascam describes SD recording for the Model 12, but lists the model under discontinued products on its European downloads page.

    Check the model version, documentation and support for the specific unit on offer.

Brands to compare

Yamaha

The MG10XU is a compact option for anyone mixing several sources and looking for a 2-in/2-out USB route.

  • Yamaha specifies four MIC/LINE inputs, +48 V phantom power and USB up to 24-bit/192 kHz.
  • The USB specification is for two inputs and two outputs, not ten separate computer tracks.

Allen & Heath

The ZEDi models vary in their USB routing and connection options, so check the full model number.

  • According to the datasheets, the ZEDi-10FX has four microphone/line inputs, two switchable Hi-Z inputs and a 4-in/4-out USB interface. The ZEDi-8 has a 2-in/2-out USB interface.
  • The selected routing determines which signals are available; don’t confuse the ZEDi with ZED models that have different specifications.

Mackie

The ProFX6v3+ is worth considering if you want to choose between different USB recording modes.

  • Mackie specifies two microphone preamps and a 2x4 USB-C audio interface. Standard records the processed main mix; Interface sends channels 1 and 2 to the computer without effects.
  • According to Mackie, Loopback also records computer playback. USB-C on its own doesn’t mean that every physical channel is recorded separately.

Tascam

According to Tascam, the Model 12 combines a mixer with an internal SD multitrack recorder and a multichannel USB interface.

  • Tascam lists 12 internal recording tracks and 12-in/10-out over USB.
  • Tascam Europe lists the Model 12 under discontinued products on its downloads page. Check the support available for the specific unit.

Soundcraft

The Notepad-8FX is a compact analogue USB mixer with built-in effects, designed for anyone who wants to create their mix directly on the mixer.

  • Soundcraft lists USB audio, Lexicon effects, a headphone volume control and level metering.
  • The product information doesn’t confirm that all eight of the mixer’s stated channels can be recorded as separate USB tracks.

Joybuy products

Related products coming soon.

Frequently asked questions

Do ten mixer channels mean I’ll get ten separate tracks over USB?

No. The number of mixer channels doesn’t automatically determine how many separate tracks are recorded over USB. Yamaha specifies 2-in/2-out for the MG10XU and Allen & Heath specifies 4-in/4-out for the ZEDi-10FX; also check the routing on the exact model.

How can I stop computer playback from accidentally ending up in my demo?

Choose your recording mode deliberately and check a short test recording. Mackie says that Loopback adds computer playback on the ProFXv3+ series, while Interface sends channels 1 and 2 to the computer without effects.

Will I need a driver on Windows?

It depends on the model and your computer. Yamaha requires a Windows driver for MG-XU models; Allen & Heath describes a separate Windows installation procedure for the ZEDi-8, ZEDi-10 and ZEDi-10FX. Check that your operating system is supported before buying.

Can I record with a mixer without a computer?

You can with a model that has an internal recorder; Tascam describes the Model 12 as recording to an SD card. Check the support and version of the device on offer, as Tascam Europe lists the Model 12 under discontinued products on its downloads page.

Who should I contact if a mixer I bought in the Netherlands is faulty?

According to the Dutch government, you should contact the seller if you have a problem with a product. There is no fixed statutory warranty period in the Netherlands; any manufacturer’s warranty is in addition to your statutory consumer protection.