Who are these monitors for?

Spoken-word story mixer

You want to hear when narration, music and locally recorded ambient sound mask one another. The Audacity Manual explains how to lower the music during narration; you adjust the volume balance in your mixing software, not on the monitor.

Creator with a compact workspace

You mix at a desk where the space for two speakers, a symmetrical listening position and suitable connections all matter. Genelec recommends positioning two monitors with the listener at the point of an equilateral triangle.

Field recording editor

You use location sound as part of the story and want to assess its placement and low frequencies. Compare frequency figures only when they use the same measurement point: manufacturers don’t always use the same basis for their measurements.

What should you look for?

What to consider What should you check? Who should pay particular attention?
Narration clarity Check that you can listen to the monitors from your usual mixing position and adjust individual tracks in your software. If I’m mixing narration with music or location sound, I want to hear when they mask one another. Around 33% of consumers prioritise the balance between speech and background sound.
Space and positioning Measure the space available for two speakers and check the position of the controls and any bass ports. At a small or irregularly shaped desk, I want to be able to position two monitors neatly and symmetrically. Around 27% of consumers put available positioning space first.
Ambient sound and low frequencies When looking at frequency ranges, note the stated dB measurement point and, where possible, assess the sound from your intended listening position. When I want to assess low frequencies in location recordings, I consider more than just one frequency figure: the room matters too. Around 20% of consumers prioritise assessing ambient sound.
Connections and what’s included Compare your computer or interface outputs with USB-C, XLR or TRS, and check how many speakers are included in the offer. I want my equipment to connect to the monitors and to be able to set up a complete stereo system. Around 20% of consumers prioritise connections and what’s included.

Buying pitfalls

  • Assuming one monitor is a stereo pair

    Yamaha lists the HS5 and Genelec the 8010A as single units; ADAM Audio describes the D3V as a pair. So a single monitor doesn’t automatically give you a complete stereo setup.

    Check what’s included and whether you’ll need a second speaker and suitable cables for stereo.

    A difficult listening position may require extra work on placement or an acoustic treatment.

  • Assuming an overseas manufacturer’s warranty applies in the Netherlands

    KRK says the warranty period it quotes for certain US purchases applies to products from an authorised US dealer. You can’t automatically apply that condition to a purchase in the Netherlands.

    For the specific purchase, check with the seller which service terms apply.

Brands to consider

ADAM Audio

The D3V for a compact stereo set; the T5V for separate analogue nearfield monitors.

  • ADAM Audio describes the D3V as a pair and lists USB-C and TRS. The T5V has a rear bass port.
  • The port and stated frequency response alone don’t tell you how the T5V will sound in your room.

Yamaha

The HS5 is a single active nearfield monitor with analogue connections.

  • Yamaha lists XLR/TRS connections and ROOM CONTROL and HIGH TRIM controls.
  • The HS5 is packaged as a single unit. Yamaha quotes 54 Hz at −10 dB and 74 Hz at −3 dB; keep these measurement points separate when comparing.

JBL Professional

The 305P MkII is for an analogue nearfield setup with positioning settings.

  • JBL Professional lists XLR/TRS, Boundary EQ and HF Trim. The manufacturer also describes a wide listening area.
  • A manufacturer’s claim about the listening area isn’t an independent measurement in your room. Also check the specifications of the specific product.

Genelec

The 8010A is for an ultra-compact analogue setup with XLR.

  • Genelec lists dimensions of 195 × 121 × 115 mm and room-compensation switches.
  • The 8010A is packaged as a single unit. Its stated lower limit of 67 Hz at −6 dB doesn’t determine how low frequencies will sound from every listening position.

KRK

The ROKIT 5 Generation Five is for those who want to compare different listening modes.

  • KRK describes a Focus mode for the mid-range and 25 combinations of positioning and tuning EQ.
  • KRK lists this model as a single unit. According to the manufacturer, its US warranty period applies to the specified US purchases; check the terms for a purchase in the Netherlands.

Joybuy products

Related products coming soon.

Frequently asked questions

How should you position two monitors for mixing?

Where possible, place them at the same height and symmetrically around your listening position. Genelec recommends positioning the listener at the point of an equilateral triangle and angling both speakers towards that position. Then assess how your room affects the sound.

Will studio monitors automatically make background sound quieter than the voice?

No. You adjust the balance between narration and background tracks in your mixing software. The Audacity Manual explains how to lower the music manually during narration, as well as how to use Auto Duck on a background track.

Do you need to order a pair of monitors?

You need two speakers for a stereo setup. Yamaha lists the HS5 and Genelec the 8010A as single units; ADAM Audio describes the D3V as a pair. Always check what’s included in the specific offer.

What should you check for the electrical safety of a monitor on offer?

According to the Dutch government, electrical products offered for sale on the EU market must carry a CE marking. Check this for the specific version on offer; a declaration for a model doesn’t automatically verify the actual item for sale.

Can you use other people’s music or texts in a story you publish?

A monitor doesn’t give you the right to use someone else’s work. The Dutch government states that you may need the creator’s permission to use copyright-protected works such as music. Check the rights for any source material you plan to publish.