Who are studio monitors for a folk demo suited to?

Mixers with a crowded desk

If you mix at a fixed workstation, first check that two monitors will fit symmetrically either side of your screen. Genelec recommends an equilateral triangle, with your listening position at the apex.

Mixers working with vocals and acoustic instruments

A consistent listening setup is important when assessing balance and stereo positioning. If you’re recording with an open microphone, listening through headphones calls for a different approach.

Mixers who also assess the bass

If you want to make decisions about low frequencies, consider the stated lower frequency limit alongside its measurement tolerance, your room and the space available for positioning. For example, Yamaha specifies 74 Hz at −3 dB for the HS5.

What should you look for when buying?

Compact active stereo pair

A good fit if: you can’t fit two larger cabinets symmetrically either side of your screen and mainly want to assess vocals and acoustic instruments.

Trade-off: the stated lower frequency limit for the PreSonus Eris 3.5 2nd Gen is 80 Hz. Check the connections on your audio source too, and use another suitable listening reference for the bass if needed.

Two compact, individual nearfields

A good fit if: you can position a symmetrical stereo pair but have limited width available for the cabinets.

Trade-off: Genelec sells the 8010A individually, so you’ll need two for stereo. Its stated low-frequency cut-off of 67 Hz at −6 dB doesn’t guarantee how the bass will sound in your room.

Larger active nearfields

A good fit if: you have enough space for two symmetrically positioned cabinets and want to focus more on instruments such as acoustic bass.

Trade-off: larger cabinets need more space. Frequency limits measured at different tolerances aren’t directly comparable, and room controls are no substitute for good positioning.

Factor to consider What to look for Who is this most relevant to?
Stereo positioning on your desk Measure the space for two cabinets and aim them both at the same listening position. Check there’s also enough clearance around connections and ports. I want to position instruments in the mix without a cramped or uneven desk dictating the setup. Around 28% of consumers rank stereo positioning as their top priority.
Balance between vocals and instruments Check whether you can create a symmetrical listening position, then listen on other familiar playback systems once the monitors are in place. I want to assess the balance between vocals, guitar and other acoustic parts, rather than choosing based only on a stated frequency limit. Around 22% of consumers prioritise this balance.
Assessing bass in your room Compare frequency limits only when they use the same dB tolerance, and take the effects of positioning and room tuning into account. I want to assess, for example, acoustic bass and understand whether the room affects the low end. Bass assessment is the top priority for around 17% of consumers.
Connecting to your audio source Make a note of the outputs on your computer or audio interface, then check the input type and how many connections each monitor needs. I want to know whether my existing audio equipment connects to the monitors and which connections I’ll need. Connectivity is the top priority for around 17% of consumers.
Buying a complete stereo system Before comparing the total cost, check whether the box contains one or two monitors and which cables are included. I want to know in advance what I need to mix with a connected stereo pair. Around 16% of consumers start by looking at the complete setup.

Common buying mistakes

  • Assuming the price of one monitor is the price of a stereo pair

    Some models are sold individually, while the PreSonus Eris 3.5 2nd Gen is sold as a pair. This means a deal on one speaker may not give you a fair comparison.

    Check what’s included in the box and which connections you’ll need before comparing the cost of a complete, connected pair.

    Extra equipment can take up space and time without solving a positioning or acoustic problem.

Brands to compare

Yamaha

  • Yamaha says the HS5 has ROOM CONTROL and HIGH TRIM. The manufacturer specifies 74 Hz at −3 dB.
  • The HS5 is sold individually; its stated frequency limit doesn’t measure the bass response in your home studio.
  • Genelec

  • Genelec specifies a width of 121 mm and one analogue XLR input per monitor.
  • The box contains one monitor. You’ll need two for stereo, and your audio equipment must have suitable outputs.
  • ADAM Audio

  • ADAM Audio specifies a rear bass reflex port and 45 Hz at −6 dB for the T5V.
  • Allow space behind the cabinet when positioning it. The claim that it’s suitable for small control rooms comes from the manufacturer.
  • JBL Professional

  • JBL lists Boundary EQ, HF Trim and balanced XLR and TRS inputs.
  • These model specifications aren’t an independent measurement of performance in your room.
  • Kali Audio

  • Kali Audio specifies a 6.5-inch woofer for the LP-6 V2.
  • The range is sold per speaker, so check the exact version and make sure you have room for two cabinets.
  • PreSonus

  • PreSonus lists TRS, RCA and 3.5mm inputs, with a stated frequency response starting at 80 Hz.
  • The low-frequency limit is worth considering if you also want to assess lower frequencies critically. Its suitability for a particular mix hasn’t been independently established.
  • Related products

    Related products coming soon.

    Frequently asked questions

    How should you position two monitors to assess stereo?

    Aim both monitors towards your listening position and place them as symmetrically as possible. Genelec recommends starting with a listening angle of 60 degrees. Then check how your desk and room affect the sound.

    Can you use monitors while recording vocals or guitar with a microphone?

    Sound from speakers can be picked up again by an open microphone and cause feedback. For these recordings, PreSonus Support recommends listening through suitable headphones; use the monitors afterwards to assess the mix.

    Is room correction the same as acoustic treatment?

    No. Genelec says calibration doesn’t solve every room problem; good positioning and, where necessary, acoustic treatment remain important.

    What can you do if a monitor bought online isn’t suitable?

    When you buy from a business at a distance, you often have a 14-day cooling-off period, according to the Government of the Netherlands. You’re also entitled to a product that works as it should; if there’s a problem, contact the seller about your legal rights. The Government of the Netherlands doesn’t specify a fixed statutory guarantee period in the Netherlands.

    Which product safety rules apply to active monitors?

    Applicable European safety and conformity rules apply to electrical equipment. Business.gov.nl explains CE marking and an EU declaration of conformity for equipment covered by these requirements. A CE mark says nothing about sound quality, and the conformity of a particular offer must be assessed separately.