Who are these monitors for?

Bass player assessing the low end

You edit bass tracks and want to tell the difference between what the speakers reveal about the low end and what’s caused by the room. Only compare frequency specifications if the dB measurement point is the same too. Manufacturers such as Genelec and ADAM Audio state frequency limits with a measurement point.

Producer short on desk space

You need to fit two listening channels and a practical listening position between your screen and other desk equipment. So check the dimensions as well as the space taken up by the cables and recommended setup.

Producer with an existing audio interface

You want to connect the monitors to the outputs you already use and know whether the product is sold as a stereo pair. Check the input types and what’s included with the exact version you’re buying; Genelec, for example, lists one 8010A per package.

What should you look for when choosing?

Compact stereo pair

A good fit if: you can fit two small speakers on your desk but don’t have much room for larger cabinets.

Trade-off: a stated low-frequency limit on its own doesn’t tell you how reliably you can assess deep bass in your room.

Separate nearfield monitors

A good fit if: you can position each monitor individually and have suitable outputs.

Trade-off: check whether you need two units for stereo; the Genelec 8010A is sold individually.

Satellites with a base unit

A good fit if: you have room for the base unit on your desk as well as the two satellites.

Trade-off: Kali Audio specifies that the base unit for the IN-UNF should be placed on the desk, not on the floor.

What to consider What to look for when buying Who should consider this?
Bass response Compare frequency limits alongside the dB measurement point; bear positioning and room resonances in mind. If you mix bass tracks, you’ll want to know what the monitors are telling you and what the room is affecting. Around 34% of consumers give assessing the low end their top priority.
Desk space Measure the width, depth and height, including stands and space for cables; check that you can angle both speakers towards your listening position. If your desk is already full, the speakers and any base unit need to fit in the space available. Around 33% of consumers prioritise their desk layout.
Connections Compare the outputs on your computer or audio interface with the monitors’ inputs; check which cables you’ll need. If you want to keep using your existing audio setup, the connections need to be compatible. Around 20% of consumers give compatibility with their setup top priority.
Complete stereo setup Check whether the package contains one monitor or a pair, and which power supplies and cables are included. If you want to connect a stereo system without missing any components, check what’s included in the specific package. Around 13% of consumers prioritise buying a complete stereo setup.

A few examples show why the measurement point matters: Genelec specifies 67 Hz at −6 dB for the 8010A, while ADAM Audio gives 45 Hz at −6 dB for the D3V. IK Multimedia lists 45 Hz at −10 dB for the iLoud Micro Monitor; that figure isn’t directly comparable with 45 Hz at −6 dB. Manufacturer specifications like these don’t, on their own, predict how the bass will sound from your listening position.

Before choosing, measure the space for the left and right speakers. Genelec describes a 60° angle with the listener as the ideal starting point for a stereo triangle. The Genelec 8010A measures 195 × 121 × 115 mm per monitor, including the Iso-Pod. With the Kali Audio IN-UNF, you’ll also need room on your desk for the base unit.

Finally, check that the inputs are compatible with your equipment: ADAM Audio lists USB-C and two balanced TRS connections for the D3V, IK Multimedia lists RCA inputs for the iLoud Micro Monitor, and Genelec lists one analogue XLR input per 8010A.

Common buying mistakes

  • Comparing the lowest Hz figure without checking the dB measurement point

    A frequency limit at −10 dB and one at −6 dB don’t describe the same level. What you actually hear is also affected by positioning and the room.

    Read the full frequency specification and assess your listening position separately; only compare figures that use the same measurement point.

  • Mistaking a single monitor for a stereo pair

    Genelec lists one 8010A per package, while Yamaha specifies the HS3 as a pair. The connections and cables you need can therefore vary depending on what’s included in the product you buy.

    Before buying, check what’s in the package and what you’ll need to connect both channels.

  • Choosing a desk system without space for the base unit

    According to the manual, the base unit for the Kali Audio IN-UNF should be placed on the desk; the manufacturer advises against placing it on the floor.

    Make sure you measure the space for the base unit before choosing this type of setup.

Relevant brands to consider

IK Multimedia

The iLoud Micro Monitor is a compact active stereo system for desks with limited space.

  • IK Multimedia lists two speakers and a power supply as included in the package.
  • The stated lower limit of 45 Hz is at −10 dB and doesn’t prove a flat response down to 45 Hz from your listening position. The manufacturer also states that latency is higher over Bluetooth than via the analogue input; a wired connection is therefore worth considering if you want to assess playback accurately.

Yamaha

The HS3 is a compact active stereo pair with analogue inputs and room control switches.

  • Yamaha lists 70 Hz at −10 dB and 85 Hz at −3 dB for the HS3.
  • These manufacturer figures alone don’t tell you how reliably you can assess deep bass in your room.

Genelec

The 8010A is a small active nearfield monitor, sold individually.

  • Genelec specifies dimensions of 195 × 121 × 115 mm, including the Iso-Pod, and a lower limit of 67 Hz at −6 dB.
  • The package contains one monitor, so you’ll need two units and suitable XLR connections for stereo.

ADAM Audio

The D3V is a compact desktop system with USB-C and balanced TRS connections.

  • ADAM Audio lists detachable stands and a frequency limit starting at 45 Hz at −6 dB.
  • This is a manufacturer specification, not an independent assessment of bass response in your room.

Kali Audio

The IN-UNF combines two desktop satellites with a separate base unit.

  • Kali Audio lists USB-C, balanced TRS and placement settings, among other features.
  • According to the user manual, the base unit should be placed on the desk, so this system isn’t suitable for a setup where the unit can only go on the floor.

Joybuy products

Related products coming soon.

Frequently asked questions

Can I connect a bass guitar directly to studio monitors to record?

No. In this setup, monitors are for playing back audio and don’t replace an instrument input. Focusrite describes an instrument input on an audio interface for recording bass directly; check separately how to connect the interface’s outputs to your monitors.

Will a subwoofer always help if I can’t hear enough bass from my desk?

No. A subwoofer won’t automatically eliminate the effect of the room. Genelec points out that factors such as positioning, crossover, level and phase all matter. So consider whether you have room for the subwoofer and the adjustments it requires.

What should I check when setting up studio monitors?

Angle both speakers towards the same listening position and check that you can position them appropriately. Genelec gives a 60° stereo triangle as the ideal starting point. If you’re using a Kali Audio IN-UNF, the manufacturer says to place the base unit on the desk, not on the floor.

What are my rights in the Netherlands regarding warranties and the cooling-off period for an online purchase?

According to the Dutch government, a manufacturer’s or seller’s warranty is in addition to your statutory rights; if a product is faulty, the seller must provide a solution. ACM ConsuWijzer states that online purchases generally come with a statutory cooling-off period of up to 14 days after delivery. Check the terms and any exceptions that apply to your purchase.

Is a CE mark a quality label for good bass response?

No. A CE mark doesn’t tell you how a monitor will reproduce bass guitar in your room. European product rules apply to relevant electrical equipment, including CE marking requirements where applicable; Dutch government information emphasises that CE is not a quality label.