Who is this choice relevant to?

Mixers working with vocal harmonies in a quiet room

You mainly work with recorded vocal tracks and want to assess the balance, sound and stereo imaging. If sound leakage isn’t an issue in your quiet workspace, isolation doesn’t need to be the deciding factor.

Home producers who also record vocals

You use the same workspace for mixing and microphone recording. In that case, it’s important to consider whether sound from the headphones could end up in a vocal recording.

Mixers with long listening sessions

You wear headphones for extended periods, so you’ll want to weigh fit, ear pads and replaceable parts against compatibility with your existing equipment.

What should you look for when choosing?

First, decide whether you’ll also be recording vocals with your headphones on. This determines whether sound leakage is an important limitation.

Open-back studio headphones

When to choose: if you mainly mix existing vocal harmonies in a quiet room and sound leaking out isn’t a problem.

Trade-off: RTINGS describes open-back models as suitable for mixing and mastering, but they leak sound and block little background noise.

Closed-back studio headphones

When to choose: if you also record vocals with a microphone in the same room, or want to keep as much sound as possible inside the headphones.

Trade-off: Neumann says closed-back monitor headphones are more commonly used for microphone recording; a closed-back design alone doesn’t prove that a model will give you a more accurate mix.

The four needs below are separate potential buying priorities; the percentages shown are approximate.

Consideration What to look for when buying Which consumers is this important to?
Balance and stereo imaging Listen to familiar vocal references to assess the mid-range and panning; check the mix on a second playback system too. When I mix existing vocal layers, I want to assess their relative levels and positioning accurately. Around 37% of consumers make this their top priority.
Sound leakage during recording Check whether the model is closed-back and whether the ear pads fit snugly; make a quiet test recording and listen back to see if any sound is audible in the microphone. When I record vocals myself, I want to prevent headphone sound from leaking into the recording. Around 27% of consumers prioritise recording and reduced leakage.
Comfort during long sessions Check the type of ear pads and the fit; if possible, try the headphones during a session of a similar length. When I mix for long stretches, I want the headphones to remain comfortable and have replaceable parts. Around 18% of consumers prioritise wearing comfort.
Connections and maintenance Compare your equipment’s output with the plug and any adapter; check which cables and parts are included with the exact version. When I work with existing equipment, I want a compatible connection and to know which parts can be replaced. Around 18% of consumers prioritise these points.

Common buying mistakes

  • Choosing an open-back model for both mixing and microphone recording

    Open-back headphones leak sound, which can be picked up by the microphone during a quiet vocal recording.

    Before buying, decide whether you’ll also use the same headphones to record vocals. If you’re unsure, make a quiet test recording and listen back to it.

    If headphone sound is audible in a take, you may need to record it again.

  • Assuming a flat-response claim guarantees a good mix

    A frequency-response claim applies to a specific model and doesn’t prove that your mix will sound the same on every playback system.

    Compare the headphones with familiar references, and check the balance and panning on a second playback system too.

  • Looking only at the plug

    Cables and connections vary between models, so a headphone plug may not be compatible with your workspace without an adapter.

    Compare the output on your audio interface or computer with the connection and accessories supplied with the exact version.

Brands to compare

beyerdynamic

The DT 900 PRO X is an open-back model for critical listening and mixing; the DT 700 PRO X is closed-back, and beyerdynamic also positions it for recording and mixing.

  • beyerdynamic lists a 48-ohm impedance for both models, along with a detachable cable featuring a 3.5 mm plug and 6.35 mm adapter.
  • The DT 900 PRO X doesn’t block out sound. beyerdynamic’s recommendation of the DT 700 PRO X for mixing doesn’t prove that it will sound better in your situation.

Sennheiser

Sennheiser positions the open-back HD 490 PRO for production, mixing and mastering when isolation isn’t the main priority.

  • Sennheiser lists two types of ear pads, a detachable cable, and replaceable, washable pads.
  • The manufacturer’s claims about spaciousness and accuracy aren’t an independent comparison. The open-back design is less suited to recording with a microphone in the same room.

Audio-Technica

Audio-Technica says the closed-back ATH-M40x is designed for both monitoring during recording and mixing.

  • Audio-Technica lists a detachable straight cable and coiled cable, and an impedance of 35 ohms.
  • The ‘flat response’ description is a manufacturer’s claim; check the sound against familiar references.

Neumann

Neumann positions the open-back NDH 30 for editing, mixing and mastering in a quiet listening environment.

  • Neumann highlights the NDH 30’s reproduction of stereo imaging and mid-range as strengths.
  • These are the manufacturer’s claims about this model, not an independent comparison. Neumann says closed-back headphones are more commonly used during microphone recording.

Sony

Sony describes the wired MDR-7506 as monitor headphones for recording and studio work.

  • Sony lists a foldable design and a supplied 3.5 mm to 6.3 mm adapter.
  • The product information supports its recording-focused design, but doesn’t establish any particular advantage for mixing vocal harmonies.

Joybuy products

Related products coming soon.

Frequently asked questions

How can I check whether my headphones are compatible with my audio interface?

Compare the headphone output on your interface with the plug and supplied adapter for the exact version. beyerdynamic’s official product information lists a 3.5 mm plug and 6.35 mm adapter for the DT 900 PRO X and DT 700 PRO X; also check which cable version is included.

Can I mix vocal harmonies using headphones alone?

You can make mixing decisions on headphones, but stereo imaging sounds different on headphones than it does through speakers. Sonarworks explains that the natural crossfeed between channels is absent when listening on headphones, so check the final balance on another playback system too.

How can I listen safely during long mixing sessions?

Keep the volume moderate and take regular breaks. The World Health Organization stresses that sound level, listening duration and frequency of exposure all matter; the volume setting on an interface doesn’t, by itself, tell you what sound level is reaching your ears.

What return and warranty rights apply to an online purchase in the Netherlands?

According to ACM ConsuWijzer, online purchases generally come with a cancellation period of up to 14 days after delivery, subject to legal exceptions. You’re also entitled to a product that meets the standard you could reasonably expect; this isn’t automatically a fixed two-year period. Before buying, check the terms and exceptions that apply to your order.

Does every wired pair of studio headphones sold in the Netherlands need a CE mark?

A CE mark isn’t automatically required for every product. Business.gov.nl says the requirement applies to products in designated product groups; ask for confirmation of the relevant product classification and conformity information for the specific model.