Who is this choice relevant to?

Creators looking to reduce shadows on paper

If you film your hands while writing, you’ll want to see the paper and brushstrokes clearly, so look for diffused light that you can direct where needed.

Creators with a shared desk

If you need to put your equipment away after filming, the panel size, mounting options and cables are all important considerations.

Creators who check colour and image quality

If you want to compare the colour of paper and ink between recordings, look for adjustable colour temperature and check test footage for visible banding.

What should you consider when choosing?

First, measure how much space you have around the paper and work out how you can mount the light. Then assess the light distribution, colour settings and power supply in your own filming setup.

What to consider What should you check? Who should pay extra attention?
Soft light and shadows Check whether a diffuser is included and whether you can position the panel to illuminate both the paper and the hand doing the writing. Assess the shadows in a test recording. If I’m filming the paper and my hand at the same time, I want the strokes to remain clearly visible. Around 36% of consumers prioritise reducing shadows.
Space and mounting Measure the clear space around your work area and check whether the package includes a tripod, clamp or other suitable mount. If I share a desk, I want to be able to put the light away after filming without leaving a permanent stand in place. Around 29% of consumers prioritise saving space and tidying away their equipment.
Paper and ink colour Check whether the colour temperature is adjustable and compare test footage using the same camera and lighting settings. If I’m filming the same work at different times, I want to record the paper and ink using comparable lighting settings. Around 21% of consumers prioritise colour consistency.
Flicker and power supply Record a video using your intended camera settings and light level, then check it for banding. Also check whether the model runs on a battery, an adapter or both. If I don’t want a recording interrupted by a flat battery or visible banding, I check the power supply and test the light beforehand. Around 14% of consumers prioritise uninterrupted recording.

Common buying mistakes

  • Assuming a high lux figure means even lighting

    Manufacturers may state light levels at different distances. A reading from one point doesn’t show how the whole sheet of paper and your moving hand will be lit in your setup.

    Only compare figures measured on the same basis, and take a test shot of the whole writing area.

  • Assuming a tripod and battery are always included

    The NEEWER NL660 is available in versions with and without a stand. NEEWER says the NP-F battery is not included; the mains adapter is listed as included with the NL660 version.

    Check the contents of the exact version you’ve chosen, and find out what mount or power supply you’ll need.

  • Treating the VL49, VL49 RGB and VL49 Pro as the same version

    Ulanzi describes the VL49 Pro as a different model from the VL49 RGB. Ulanzi and the Joybuy product listing also give different upper limits for the VL49 RGB’s colour temperature.

    Compare the full model name and the specifications of the version you’ve chosen before matching a product listing to a model.

Brands to compare

NEEWER

The NL660 is a larger bi-colour panel for a setup where you want to adjust the direction and diffusion of the light.

  • NEEWER gives the NL660 a colour temperature range of 3200–5600 K and says a diffuser is included.
  • According to the manufacturer, it can be powered using the included adapter or a separately available NP-F battery. NEEWER says a stand is only included with the ‘with Stand’ version, so check which bundle you’re choosing.

SmallRig

The P96 is a compact panel for a portable setup, provided you can mount it suitably beside your work area.

  • SmallRig lists a built-in battery, a cold shoe mount and a colour temperature range of 2700–6500 K for the P96.
  • The manufacturer states 150 lux at 1 m; this figure doesn’t prove that one panel will illuminate a whole sheet evenly. Also check whether you have a suitable desk clamp or stand.

Godox

The LEDP260C is a larger panel for a permanent setup or a desk that you set up from scratch each time.

  • The Godox manual lists a colour temperature range of 3300–5600 K and power via an adapter.
  • The manual says NP-F970 batteries must be purchased separately. At colour temperatures between the two end points, the minimum dimming level is higher than at either end. The LEDP260C is not the same model as the P260C Pro.

Ulanzi

The VL49 RGB is a compact, rechargeable light for a small work area or as an additional light source.

  • According to Ulanzi, the VL49 RGB has a 2000 mAh battery, a magnet and mounting points.
  • Ulanzi gives a different upper limit for the colour temperature from the Joybuy product listing. Check the exact version and specifications; the VL49 Pro is a different model.

amaran

The P60x is a larger bi-colour panel for anyone with room for a less temporary setup.

  • According to amaran, the P60x has a power output of 60 W, a colour temperature range of 3200–6500 K and a softbox included in the box.
  • These are manufacturer specifications; the stated power output doesn’t tell you how much light your particular desk setup needs.

Products on Joybuy

Related products coming soon.

Frequently asked questions

Where should you position the panel for an overhead shot?

Position a diffused panel so it lights the paper without shining directly into the lens. Take a test shot while writing: the right position depends on your camera, writing direction and work area.

What can you do if dark bands appear across your video?

First, test your own light with your camera. For areas with a 50 Hz mains frequency, Sony suggests a shutter speed of 1/50 or 1/100 of a second as a possible setting; what works depends on the camera and situation. This doesn’t guarantee that every LED light will record without banding.

Can you put a battery-powered panel on a desk without any extra parts?

Not always. SmallRig lists a cold shoe mount for the P96, while NEEWER offers the NL660 in versions with and without a stand. Check what’s included with the version you’ve chosen and whether you’ll need a suitable mount.

What costs and consumer rights should you consider when buying online in the Netherlands?

Check whether the battery, adapter and stand are included with the version you’ve chosen; NEEWER says the NP-F battery is not included with the NL660. ACM ConsuWijzer states that online consumer purchases come with a statutory 14-day cooling-off period after delivery, subject to exceptions. According to the ACM, the seller remains responsible for the statutory guarantee if a product doesn’t do what you could reasonably expect it to.

Is CE marking relevant for an LED video light?

CE marking is only required for products covered by harmonised EU rules that specifically require it. The European Commission stresses that the applicable rules must be determined for each product. CE marking doesn’t prove that a light will record without flicker.