Who are these studio monitors for?

Guitar editor with two screens

You want to assess pick attack, incidental noise and the stereo placement of acoustic guitar, but your screens limit where the speakers can go. Start with a clear, symmetrical listening setup. Genelec explains how the room and large objects can affect the sound.

Musician without an audio interface

You edit music on a computer and want a compact stereo set with a direct digital connection. ADAM Audio and Kali Audio list USB-C for the D3V and LP-UNF respectively. Check that the connection works as an audio input in your computer setup.

Mixer with an audio interface

You have suitable analogue outputs and want to compare separate monitors or optional room calibration. Check the connections, available space and what you need for the measurement setup. Neumann lists a measurement microphone, a suitable interface and network connections among the requirements.

What should you look for?

Compact desktop set with USB-C

Choose this option: if two screens leave you with little room, or you want to connect the set directly to a compatible computer.

Bear in mind: the space available and cable routing; stated bass response is only comparable when measured to the same standard.

Two separate active nearfield monitors

Choose this option: if your audio interface has suitable analogue outputs and you can position each speaker separately.

Bear in mind: the Yamaha HS5 and Genelec 8010A are sold individually, so check how many speakers you need for stereo.

DSP monitor with optional room measurement

Choose this option: if you want to measure your listening position and are prepared to buy and set up the equipment needed for calibration.

Bear in mind: Neumann’s MA 1 requires additional equipment and is no substitute for a practical, symmetrical speaker setup.

What to consider What to look for when buying Who is this important for?
Clear, symmetrical placement Measure the space beside both screens and check that the sound paths remain unobstructed. Genelec recommends a 60° angle between the monitors, ideally with the listener at the point of an equilateral triangle. If I want both speakers to fit comfortably beside my screens, I start by checking the space available. Around 28% of consumers say placement is their top concern.
Guitar detail and stereo image Check that screens and other objects do not block the direct sound path. Genelec notes that room surfaces and large objects can cause reflections. If I want to assess pick attack and the position of guitar tracks in stereo, I look for a clear, balanced setup. Around 28% of consumers make guitar detail their top priority.
Connection to a computer or interface Check the connections at both ends: ADAM Audio lists USB-C and balanced TRS for the D3V; Kali Audio lists USB-C for the LP-UNF. Yamaha lists XLR and TRS inputs for the HS5. If I want to work without a separate interface or use my existing outputs, I first check which connections my equipment supports. Around 17% of consumers put connectivity first.
Bass response in your room Compare frequency figures only when they use the same measurement limit: Yamaha gives the HS5 as 54 Hz at −10 dB and 74 Hz at −3 dB; Kali lists the LP-UNF at 39 Hz at −10 dB and a response from 54 Hz within ±3 dB. If I want to assess the bass balance of my guitar recording at my own listening position, I consider both the measurement standard and the setup. Around 16% of consumers say bass response is their top concern.
Complete stereo set and required equipment Check the package contents and required cables: Yamaha lists the HS5 and Genelec the 8010A as single units. Neumann’s MA 1 also requires a measurement microphone and a suitable audio interface, among other equipment. If I want to set up a complete stereo pair, I need to know how many speakers and what additional equipment my chosen option requires. Around 11% of consumers make a complete set their top priority.

Common buying mistakes

  • Choosing a monitor without checking your two-screen setup

    Screens and other objects can block the direct sound path. Uneven reflections from the left and right can affect how you assess a stereo mix.

    Measure or sketch out your final listening setup before choosing a size. Keep both sound paths clear and check that you can position the speakers symmetrically.

    If your desk does not offer enough room, you may need to rearrange it or use suitable stands.

  • Comparing bass cut-off figures as though they were measured on the same basis

    A frequency figure at −10 dB is not directly comparable with one at −3 dB. Yamaha and Kali list multiple measurement limits for their models.

    Check the measurement limit and the full stated frequency range. Then assess how the bass balance sounds at your intended listening position.

  • Assuming one monitor is a stereo pair

    Yamaha specifies the HS5 and Genelec the 8010A as single units, while you need two speakers for stereo.

    Check the quantity, connections and included components for each listing.

    You may need to buy a second speaker for a stereo pair. If you choose Neumann’s MA 1 calibration, you will also need additional measurement equipment.

Brands to compare

ADAM Audio

ADAM Audio describes the D3V as an active desktop set for compact workspaces, with USB-C or two balanced TRS connections.

  • ADAM Audio lists detachable stands and switches for different placement options.
  • The stated lower limit of 45 Hz applies at −6 dB; do not compare this figure directly with values measured to a different limit.

Kali Audio

Kali Audio describes the LP-UNF as designed for desktop use, with USB-C, balanced TRS and unbalanced RCA connections.

  • Kali Audio specifies settings for different desk, stand and wall positions.
  • Kali lists 39 Hz at −10 dB and a response from 54 Hz within ±3 dB. Claims about the stereo image are the manufacturer’s statements, not a guarantee for every listening position.

Yamaha

Yamaha describes the HS5 as a separate active nearfield monitor for setups with suitable analogue outputs.

  • Yamaha lists XLR and TRS connections, along with ROOM CONTROL and HIGH TRIM controls.
  • The HS5 has a 5-inch woofer and is sold individually. Yamaha lists 54 Hz at −10 dB and 74 Hz at −3 dB; you need two units for stereo.

Genelec

Genelec describes the 8010A as a small, separate active monitor with an analogue XLR input and placement controls.

  • Genelec lists a width of 121 mm with the Iso-Pod and a lower limit of 67 Hz at −6 dB.
  • The package contains one monitor. Its compact size alone does not prove that its bass response will be sufficient at every listening position.

Neumann

Neumann’s KH 80 DSP offers DSP settings and an optional MA 1 setup for measuring and calibrating your listening position.

  • Neumann lists settings for different desktop and free-standing positions.
  • For MA 1, Neumann lists a specific measurement microphone, a suitable interface and network connections among the requirements.

Joybuy products

Related products coming soon.

Frequently asked questions

Where should you place your speakers when two monitors fill your desk?

Place them as symmetrically as possible on either side, at the same height and angled towards your listening position. Genelec recommends a 60° angle between the speakers, ideally with the listener at the point of an equilateral triangle. Keep the direct sound path clear of screens and other objects.

Can you connect the monitors without an audio interface?

It depends on the model and your computer. ADAM Audio lists a USB-C audio connection for the D3V, and Kali Audio lists USB-C for the LP-UNF. The Yamaha HS5 uses analogue XLR or TRS inputs, so check that your computer or other equipment has suitable outputs.

Can a desk or room setting help when speakers are close to screens and walls?

A placement setting may help correct for differences caused by where the speakers are positioned, but it is no substitute for a practical, symmetrical setup. Genelec explains how a desk and other large objects can cause reflections. Neumann’s optional MA 1 measurement with the KH 80 DSP requires additional equipment.

Should you buy one monitor or two?

Check the package contents for the exact model. Yamaha lists the HS5 and Genelec the 8010A as single units, so you need two for a stereo pair. ADAM Audio describes the D3V as a pair.