Who is this relevant to?

Groups working with different page sizes

Measure the largest single page or spread in both directions before choosing a scanning area. This will tell you whether it can fit in a single scan.

Groups with bound sketchbooks

If drawings extend close to the spine, check how the book sits on the glass and whether you can place it there without putting pressure on the binding.

Groups that scan regularly

If group members take turns scanning lots of pages, you’ll also need to consider manual page placement, the computer and the steps involved in saving files.

What should you look for?

Compact A4 flatbed

A good fit when: the area you want to capture is no larger than 216 × 297 mm and the page can lie on the glass without damaging pressure.

Keep in mind: a larger page or spread won’t necessarily fit in a single scan. A lid designed for thicker originals is no guarantee that a tricky book fold will be easy to scan.

Book-friendly A4 flatbed

A good fit when: you want to scan a bound A4 page with an image close to the spine. Plustek lists a 6 mm book edge for the OpticBook 3800L.

Keep in mind: the scanning area is still 216 × 297 mm, and your book must sit properly on the scanner without being forced into place.

A3 flatbed

A good fit when: the page or spread you want to scan is larger than A4 but fits within the scanning area of your chosen model.

Keep in mind: Plustek lists a maximum scanning area of 297 × 431,8 mm for the OpticSlim 1180. The model also needs worktop space and a separate power supply.

Next, compare the intended file formats and software with the group’s computer, and, if possible, start with a test scan of representative work.

What to consider What should you check? Who is this important for?
Scanning area Measure the width and height of the largest page or spread. Canon lists a maximum of 216 × 297 mm for the CanoScan LiDE 400; Plustek lists a maximum of 297 × 431,8 mm for the OpticSlim 1180. If I want to keep whole pages or spreads in a single scan, I compare their dimensions with the scanning area. Around 33% of consumers say page size is their main priority when choosing.
Binding and placement Check where the drawing starts in relation to the spine and whether your book sits on the glass without being forced into place. Plustek lists a 6 mm book edge for the OpticBook 3800L; Canon says the LiDE 400’s Z-lid accommodates originals up to 21 mm thick. If I want to capture work near the spine without putting pressure on the binding, I check how the book actually sits on the scanner. Around 25% of consumers say protecting the binding is their top priority.
Image detail and files Decide whether the scans will be viewed online, edited or printed, and make a test scan. A stated maximum optical resolution is not an independent measure of colour reproduction. If fine lines and areas of colour need to remain usable for their intended purpose, I want to assess the output using representative work. Around 25% of consumers prioritise usable image detail.
Shared use Check the connection, workspace, power requirements, and available drivers and software for the group’s computer. If several group members take turns scanning pages, I want connecting the scanner, placing pages and saving files to be practical. Around 17% of consumers say the group workflow is their top priority.

Common buying mistakes

  • Choosing based on the A3 or A4 label alone

    The label alone doesn’t tell you whether your entire page or spread will fit in a single scan.

    Measure the original’s width and height, then compare both dimensions with the scanning area of the exact model.

    If a page won’t fit in one scan, you may need to take extra scans and edit them afterwards to join the images together.

  • Assuming a deep lid will solve every spine-related problem

    Clearance beneath the lid and the way a book edge sits against the glass are two different placement considerations.

    Check with your own sketchbook that the page lies flat without being forced and that details near the spine remain visible.

    If the book doesn’t sit properly, you may need to reposition it or scan it again.

  • Comparing only the highest dpi specification

    A stated maximum is not an independent measure of colour reproduction or of the result you’ll get with a particular drawing.

    First decide how the group will use the files, then assess a test scan of representative work.

  • Sharing a group archive without agreeing permissions

    The Dutch government states that a private copy for personal use must not be distributed or made public.

    Before sharing scans, confirm with each artist what permission applies to keeping and sharing their work.

Relevant brands to consider

Canon

The CanoScan LiDE 400 is a compact A4 flatbed for loose pages and originals that fit under its Z-lid.

  • Canon specifies a maximum size of 216 × 297 mm, USB power and clearance under the Z-lid for originals up to 21 mm thick.
  • The stated scan speed is for A4 colour at 300 dpi, excluding transfer time. It is not a measured end-to-end time for a group scanning session.

Epson

Epson describes the Perfection V39II as a compact A4 photo and document scanner with USB power, buttons and a built-in stand.

  • USB power and the built-in stand may be useful when setting up a small scanning station.
  • An A4 model isn’t designed to scan a larger page in a single pass on the scanning area.

Plustek

The OpticBook 3800L and OpticSlim 1180 offer different scanning areas and are designed for different placement needs.

  • Plustek lists a 6 mm book edge for the OpticBook 3800L and a maximum scanning area of 297 × 431,8 mm for the OpticSlim 1180.
  • The book edge and larger scanning area are features of different models; they are not combined in a single scanner.

Joybuy products

These models combine an A4 flatbed for bound material with a document feeder for loose pages. Check that the size you need fits on the glass, and that the connection and software are compatible with the group’s computer.

Canon imageFORMULA DR-F120 A4 flatbed scanner with document feeder

Canon imageFORMULA DR-F120 Flatbed & ADF Scanner, 600 × 600 dpi, A4

The flatbed is suitable for A4 pages that fit on the glass; the product description also mentions books and delicate materials.

Specifications list 600 × 600 dpi, a 50-sheet feeder, duplex scanning, CaptureOnTouch 3 and output to editable PDF.

View at Joybuy
Epson WorkForce DS-1660W A4 flatbed scanner

Epson WorkForce DS-1660W Flatbed Scanner, 1200 × 1200 dpi, A4

The flatbed may suit A4 pages that fit on the glass; the product description also mentions books and bound documents.

Specifications list 1200 × 1200 dpi, automatic duplex scanning, and USB and wireless connectivity. Check that the necessary software is available for the group’s computer.

View at Joybuy

Frequently asked questions

What measurements should you take before choosing a scanner?

Measure the full page or spread you want to save as a single image, both widthways and heightways. Compare these dimensions with the scanning area of the exact model: the Canon CanoScan LiDE 400 measures up to 216 × 297 mm, while the Plustek OpticSlim 1180 measures up to 297 × 431,8 mm.

Will a higher dpi figure automatically give you a better scan of a drawing?

No. A higher stated dpi figure doesn’t automatically mean better colour reproduction or a better scan of your drawing. Choose settings to suit how you plan to use the scan, whether viewing, editing or printing, and assess a test scan if possible.

What should you check before installing the scanner on the group’s computer?

Check that suitable drivers and software are available for the exact model and the computer used by the group. Canon lists USB power for the LiDE 400; Plustek also specifies a separate AC power supply for the OpticSlim 1180.

How can you make scanning several sketchbooks manageable?

Agree in advance how pages will be placed and files named, and allow for manually changing pages. Check an initial scan for cropped edges and details near the spine before scanning a whole book.

Can the group share scans of other people’s sketches with one another or online?

Not simply because the group owns the physical sketchbook or scanner. The Dutch government states that a private copy for personal use must not be distributed or made public. Before sharing copyright-protected work, ask the rights holder for permission or check what permission has already been granted.