What should you look for in an audio interface for cassette transfers?
First check whether your existing USB audio equipment is already suitable. If you choose an interface, then decide what channel separation and listening controls you need while recording.
| What to consider |
What should you check? |
Who is this important to? |
| Recording the left and right channels separately |
Check whether your deck has two outputs, the interface offers two line-compatible inputs, and the recording can be set to two channels. Separately, check whether direct monitoring plays back in stereo. |
If you want to assess a tape’s stereo balance during the transfer, pay attention to both the recording channels and the monitoring mode. Around 36% of consumers give separate stereo recording top priority. |
| Listening directly and checking the recording |
Check the headphone output, volume control and direct-monitor or mix control. Listen back to a short recording, too. |
If you want to hear what the deck is sending straight away at your desk and then check the file, consider the listening route and software monitoring. Around 29% of consumers prioritise direct, adjustable monitoring. |
| Controls and cabling at a standing desk |
Check that you can reach the connections and controls, and that the cables have enough room when you adjust the desk. |
If you want to operate the interface during a transfer at an adjustable desk, equipment and cable placement matter. Around 21% of consumers prioritise a practical workspace set-up. |
| A simple set-up without unnecessary purchases |
Test your existing USB audio equipment and make a short test recording. Check the deck and recording level, too. |
If you want to see whether your existing equipment will do the job and rule out problems with the source, start with a test. Around 14% of consumers give reusing equipment and keeping things simple top priority. |
Audio interfaces at Joybuy
Related products will be available soon.
Frequently asked questions about cassette transfers
Do I need one or two interface inputs for a stereo deck?
To record the left and right outputs separately, you need two suitable inputs and a two-channel recording. According to Focusrite, each 6.35 mm jack input on the Scarlett 2i2 discussed here is a mono input.
How can I check the recording without hearing a delayed, doubled signal?
First, make a short test recording. Listen directly through the interface if that feature is available, then check the saved file. If you hear an echo, check whether software monitoring of the same signal is also switched on. Arturia explains that listening directly and through software at the same time can result in doubled playback.
Can a different interface fix a cassette that sounds poor?
No, an interface won’t fix a problem with the cassette or deck by itself. Audacity explains that dirt on the playback head can reduce high frequencies and increase noise. So check the deck, too, and use a test recording to set the level so the signal doesn’t clip.
What can I do if the interface doesn’t work properly after I buy it?
According to the Netherlands government, you’re entitled to a product that works properly in the Netherlands, and you can contact the seller if a product is faulty. A manufacturer’s warranty is extra; there is no fixed statutory warranty period for every product in the Netherlands.
Can I digitise and share copyrighted music from my cassette?
The Netherlands government allows you to make a private copy for your own use, but says you must not distribute it or make it available to the public. The private-copy exception therefore doesn’t give you permission to share the copy.