Who is this guide for?

Reviewer of restored files

You compare existing recordings with edited versions and want the controls and headphone socket within easy reach. Audacity explains that listening to the residual audio removed during noise reduction can help you judge whether any wanted speech or music has been lost too.

Digitiser of analogue stereo archives

You review restorations and also want to record two channels from an analogue source at the same time. In that case, two suitable line inputs and the connections on your source are key.

Listener with an existing computer setup

Your choice depends on your computer, headphones and any active monitors. Check the requirements and connections of the exact model against your own equipment.

What should you look for?

First decide whether you only want to listen to existing files or also record analogue audio. Then check the controls, connections and compatibility with your workspace.

What to consider What should you check? Who should pay particular attention?
Comparing the original and restored versions Check the headphone socket, volume control and connections for your speakers. I want to review the original and edited versions using the same listening setup. Consumers with this priority account for around 33% of consumers in this breakdown.
Controls at a sit-stand desk Check where the headphone socket and volume control are; also allow for connected plugs and cables. When I move the desk, I want to keep the controls and connections within easy reach. Consumers who prioritise easily accessible controls account for around 27%.
Digitising analogue stereo Check that there are two line inputs you can use at the same time and that the plugs match your source’s outputs. I want to record the left and right channels from an analogue source at the same time. Consumers with this recording need account for around 20%.
Connecting to your existing equipment Compare the published system and power requirements with your computer, and check the plugs on your headphones and monitors. I want to keep using my existing computer and listening equipment. Consumers for whom compatibility is the deciding factor account for around 20%.

Common buying mistakes

  • Confusing direct monitoring with playback of the restored version

    Direct monitoring may let you hear the untreated input signal, rather than the edited recording you want to review.

    Play the original and the result in your audio software. If you’re using noise reduction, you can also listen to the removed residual audio if needed.

  • Assuming two inputs are all you need for a stereo setup

    Your analogue source’s outputs need to match two suitable inputs, with the left and right channels connected correctly.

    Before choosing a model for digitisation, check the source outputs, plugs and input type.

    You may need extra cables or adapters to make the connection work.

  • Looking only at the casing

    Cables at the back and a connected headphone plug also take up space. They also need enough slack to move when you raise or lower the desk.

    Plan where to place the interface with the plugs connected, and check that the volume controls remain within reach at both desk heights.

Brands to consider

The features listed are product specifications for these models and can help you work out which connections and controls suit your workflow.

Focusrite

The Scarlett 2i2 4th Gen is worth considering if you want to connect headphones and active monitors, or also record an analogue stereo source.

  • Focusrite specifies two balanced TRS monitor outputs, a headphone socket on the front and two separate mono inputs for this model.
  • If you’re only listening to existing files, the recording inputs aren’t in themselves a restoration feature.

MOTU

The M2 is an option to consider if its connections suit your source and listening equipment.

  • MOTU lists two combination XLR/TRS microphone/line inputs and two balanced TRS line outputs.
  • For an analogue stereo source, check that the plugs and input connections match your own equipment.

Audient

The iD4 MKII is worth considering if two headphone sockets or loopback are important for your setup.

  • Audient lists two headphone sockets, two line outputs and loopback for this model.
  • For bus power, Audient specifies a minimum of 5 V and 0,9 A via a USB 3.0 port. Check this requirement if you’re considering the model.

Arturia

The MiniFuse 2 is worth considering if you also want to make simple recordings as well as play audio, and mix the input with your computer’s output.

  • Arturia describes a control that lets you mix the input signal with the signal from your computer.
  • Direct monitoring lets you hear the input; it doesn’t replace playing back a restored file.

RME

The Babyface Pro FS is worth considering if adjustable monitor output levels and more advanced routing suit your workflow.

  • RME lists a +19/+4 dBu switch and TotalMix FX.
  • First decide whether you need those extra settings; they aren’t essential for reviewing existing audio files.

Audio interfaces on Joybuy

Related products coming soon.

Frequently asked questions

Do I need two recording inputs to review existing archive files?

No, not for playing and comparing existing files. If you also want to record an analogue stereo source at the same time, two suitable line inputs are important.

Can I use direct monitoring to assess the effect of a restoration?

Not if direct monitoring plays the untreated input directly. Play the original and edited file in your audio software; Audacity also explains that listening to the removed residual audio can be useful when using noise reduction.

How do I connect headphones and speakers?

Compare the plugs and inputs on your equipment with the connections on the exact model. For example, Focusrite specifies a 6,35 mm headphone socket on the front of the Scarlett 2i2 4th Gen, and two balanced 6,35 mm TRS monitor outputs on the back.

How can I reduce the risk during long listening sessions?

Start at a low volume and consider both the sound level and how long you listen. The World Health Organization explains that higher levels and longer exposure increase the risk of hearing damage; the volume setting on an interface doesn’t directly measure the level at your ears.

What cooling-off period and statutory guarantee apply to an online purchase as a consumer in the Netherlands?

For an online distance purchase from a business, a 14-day cooling-off period applies in many cases, with some exceptions. You’re also entitled to a statutory guarantee if a product doesn’t meet what you could reasonably expect under normal use. The Netherlands Authority for Consumers and Markets states that there is no fixed standard period for this; these consumer rules don’t necessarily apply to business purchases.